Installation & Repair

How much does a control and valve installer and repairer make?

The median control and valve installer and repairer in the United States earns $74,690 per year, about $35.91 an hour. That is the midpoint of the profession: half of all control and valve installers and repairers earn more, and half earn less.

Median annual salary
$74,690
Median hourly wage
$35.91 /hr
Employed in the U.S.
46,920

Source: BLS OEWS, May 2024. SOC code 49-9012.

Control and valve installer and repairer salary range

Pay for control and valve installers and repairers spans a wide band. The lowest paid 10 percent earn under $43,840 a year, while the highest paid 10 percent take home more than $109,050. The average (mean) wage of $75,970 runs a bit higher than the median, which is normal for jobs where a group of top earners pulls the average up.

Percentile Annual Hourly
10th percentile $43,840 $21.08 Lowest paid
25th percentile $53,060 $25.51
Median (50th) $74,690 $35.91 Midpoint
75th percentile $97,400 $46.83
90th percentile $109,050 $52.43 Highest paid

Figures are national wage estimates for control and valve installers and repairers, except mechanical door (SOC 49-9012), U.S. Bureau of Labor Statistics, OEWS, May 2024.

Control and valve installer and repairer salary by state

Where you work changes the paycheck. Control and valve installers and repairers earn the most in Alaska at $106,250 a year, and the least in Florida at $53,310. The table below lists every state with published data, ranked by median annual salary.

State Median annual Employed
Alaska $106,250 50
Washington $105,130 530
North Dakota $101,780 300
New York $101,230 4,380
Connecticut $98,840 560
District of Columbia $96,560 50
Massachusetts $94,880 1,740
California $94,280 4,100
Michigan $92,100 2,760
Wisconsin $90,540 570
Oregon $88,600 440
Illinois $86,740 N/A
Nebraska $86,290 480
South Dakota $84,900 140
Iowa $83,970 720
Montana $83,600 90
Wyoming $83,290 300
West Virginia $82,010 670
Kansas $81,830 410
Delaware $81,580 180
Idaho $81,040 200
Missouri $81,030 600
Vermont $80,760 60
Hawaii $79,900 100
Pennsylvania $76,360 1,690
Minnesota $74,690 1,390
Arizona $73,610 560
Nevada $70,560 100
Arkansas $70,190 470
Utah $69,450 340
Oklahoma $69,310 1,030
Virginia $68,580 950
Maine $68,130 160
Colorado $66,570 690
Ohio $66,070 1,370
New Hampshire $66,000 260
New Mexico $65,650 190
Louisiana $64,990 550
North Carolina $62,650 1,220
Kentucky $62,420 570
Tennessee $61,820 610
Georgia $61,440 990
South Carolina $61,410 360
Alabama $61,200 420
Indiana $60,440 910
Maryland $59,890 920
Mississippi $55,000 280
Texas $54,880 8,470
Florida $53,310 1,310

State median wages for control and valve installers and repairers, except mechanical door (SOC 49-9012), U.S. Bureau of Labor Statistics, OEWS state files, May 2024. States where the BLS does not publish a median are not shown.

Job outlook for control and valve installers and repairers

The BLS projects employment of control and valve installers and repairers to grow 4.3% from 2025 to 2035. That is about as fast as the 3.5% average for all occupations. That works out to roughly 50,400 jobs in 2025 moving toward 52,600 by 2035.

Across the decade, the BLS expects about 3,600 openings a year for control and valve installers and repairers. Most come from the need to replace workers who move to other jobs or leave the workforce, on top of any new positions from growth.

Source: U.S. Bureau of Labor Statistics, Employment Projections program, 2025-35 (Table 1.2, Occupational projections and worker characteristics).

How to become a control and valve installer and repairer

The typical entry-level education for control and valve installers and repairers is a high school diploma or equivalent, according to the BLS. New hires typically complete moderate-term on-the-job training to reach full competency.

A four-year college degree is usually not required to start, which makes this one of the jobs you can enter without a bachelor's degree. See more high paying jobs without a degree .

Education, training, and experience data: U.S. Bureau of Labor Statistics, Employment Projections program.

What affects how much a control and valve installer and repairer earns

Certifications, the type of equipment worked on, employer, and region drive most of the pay difference. Flat-rate pay and overtime can push experienced techs well above the median.

Location is one of the clearest factors. The gap between the top paying state (Alaska, $106,250) and the lowest (Florida, $53,310) shows how much geography alone can move the number, before experience or specialization.

About 46,920 people work as control and valve installers and repairers in the United States. At $74,690 a year, the job pays above the $49,500 median for all U.S. jobs.

Control and valve installer and repairer salary FAQ

How much does a control and valve installer and repairer make an hour?

The median hourly wage for a control and valve installer and repairer is $35.91. The middle half of control and valve installers and repairers earn between $25.51 and $46.83 per hour.

What is the highest control and valve installer and repairer salary?

The highest paid 10 percent of control and valve installers and repairers earn more than $109,050 per year. Top earners usually have the most experience and work in the best paying regions and industries.

How much does a control and valve installer and repairer make a year?

The median annual salary for a control and valve installer and repairer is $74,690. The average (mean) wage of $75,970 runs a bit higher than the median, which is normal for jobs where a group of top earners pulls the average up.

Is being a control and valve installer and repairer a well paid job?

At $74,690 a year, a control and valve installer and repairer earns above the $49,500 median for all U.S. jobs. About 46,920 people work as control and valve installers and repairers in the United States.

Which state pays control and valve installers and repairers the most?

Alaska has the highest median salary for control and valve installers and repairers at $106,250 a year. Washington ($105,130) and North Dakota ($101,780) follow. State medians come from the BLS OEWS state files, May 2024.

Is being a control and valve installer and repairer a good career?

Employment of control and valve installers and repairers is projected to grow 4.3% from 2025 to 2035, about as fast as the 3.5% average for all occupations. The BLS projects about 3,600 openings each year, from growth and from workers leaving the occupation.

Do you need a degree to become a control and valve installer and repairer?

No. The BLS lists the typical entry-level education for control and valve installers and repairers as a high school diploma or equivalent, so a four-year degree is usually not required to start.

Related salaries

See more in Installation & Repair salaries or browse the highest paying jobs in the U.S.

Sources. National and state wage and employment figures: U.S. Bureau of Labor Statistics, Occupational Employment and Wage Statistics (OEWS), May 2024 and the OEWS state files. Growth, openings, education, and training: U.S. Bureau of Labor Statistics, Employment Projections program (2025–2035). Every figure on this page is published by the BLS and is shown without adjustment. View the originals at bls.gov/oes and bls.gov/emp. Last updated 2025-04-02.